Project Description
Optimized Internal Ribbed Boiler Tubes
Product Description
Internal ribbed tubes are widely used in the water-cooled walls of boilers in power plants. They are primary heat exchange components where spiral protrusions on the inner wall of the tube cause the water inside to rotate, disrupting the film effect during heat transfer and achieving nucleate boiling. These tubes come in two types: standard internal ribbed tubes and optimized internal ribbed tubes.
Standard internal ribbed tubes come in A and B types with a helical angle of 30°, which increases heat transfer efficiency by about 30% compared to ordinary round tubes. Optimized internal ribbed tubes represent the next generation developed from traditional internal ribbed tubes, featuring a helical angle exceeding 40°. Compared to standard internal ribbed tubes, they further enhance heat transfer efficiency by an additional 20%, thus offering superior heat transfer performance. Below is a comparison of the heat transfer characteristics of smooth tubes, standard internal ribbed tubes, and optimized internal ribbed tubes.
Comparison of Parameters for Some T12 Optimized Internal Ribbed Tubes Produced by Company vs Foreign Data
| Manufacturer | Outer Diameter (mm) | Wall Thickness (mm) | Number of Threads | Thread Height (mm) | Thread Top Width (mm) | Helical Angle (°) | Thread Side Angle (°) |
|---|---|---|---|---|---|---|---|
| Benteler | 35*6.5 | 34.92 | 20.55 | 6 | 1.26 | 5.81 | 42 |
Company |
31.8*5.5 | 31.75 | 20.15 | 6 | 1.25 | 5.91 | 42 |
Company |
34.9*6.1 | 34.96 | 21.40 | 6 | 1.31 | 6.04 | 44 |
Current Grades of Steel Produced
20G, SA210C, SA210A1, 15CrMoG, 12Cr1MoVG, T2, T12, T23, T91
Standards Implemented (Partial List):
- GB5310-2008, GB/T 20409-2006: Seamless steel tubes for high-pressure boilers with internal ribs
- ASME SA-210M-2015
- ASME SA-213M-2015
Specification Range:
- Outer Diameter: Φ22mm ~ Φ82.6mm
- Wall Thickness: 4.0mm ~ 16.0mm
Optimized ribbed tube data
The optimized profile exists for the part of the furnace where standard ribs are not enough — high heat flux combined with low mass flux, where a standard rib can still allow film boiling. The higher rib promotes swirl earlier and keeps the water against the wall.
| Standard | GB/T 20409-2006; GB 5310-2008; ASME SA-210M; ASME SA-213M |
| Type | Optimized (high-efficiency) internal rib, in addition to Type A and Type B |
| Difference from standard rib | Higher rib and adjusted lead, giving a larger internal surface and earlier transition to nucleate boiling at low mass flux |
| Grades | 20G, SA210A1, SA210C, 15CrMoG, 12Cr1MoVG, T2, T12, T23, T91 |
| Outside diameter | 22 mm – 82.6 mm |
| Wall thickness | 4.0 mm – 16.0 mm |
| Delivery condition | Normalized or as-rolled by grade |
| Testing | Hydrostatic, eddy current; rib geometry checked on a sectioned sample |
| Certificate | EN 10204 3.1 |
Because rib geometry is rolled to a drawing, an optimized tube is not interchangeable with a standard one at the same OD and wall. Send the drawing or the OEM part number if the tube is a replacement for an existing unit.
