Project Description

High Pressure Feedwater Heater Pi (π) Type Tubes — Hunan Fushun Metal

High Pressure Feedwater Heater Pi (π) Type Tubes

Product Description

To reduce the loss of heat carried away by cooling water in condensers, feedwater heating is implemented to minimize this loss. After the high-pressure feedwater pumps, high-pressure heaters are added to increase the temperature of the boiler feedwater, thereby enhancing economic efficiency and conserving coal resources. The heat exchanger tubes are a critical component of these systems, available in various forms such as U-tubes, π-tubes (flat-bottomed tubes), and straight tubes.

The π-type tubes (flat-bottomed tubes) serve a similar purpose to U-tube heat exchangers and are primarily used in smaller capacity units, mainly due to considerations regarding equipment size and cost.

Main Grades or Steel Levels

  • ASME SA-556C2
  • 20MnGJ

Standards for Products

  • ASME SA-556M: Seamless cold-drawn carbon steel tubes for feedwater heaters
  • GB/T 24591-2009: Seamless steel tubes for high-pressure feedwater heaters

Features of the Product

The tubes are long (up to over 35 meters in length) and thin (with a length-to-diameter ratio greater than 1000). Due to the requirements of production and usage environments for high-pressure heaters, they must meet high standards for straightness (full length passing through a ring gauge +0.02mm larger than the maximum outer diameter), have stringent requirements for surface roughness, and must be free from rust.

Usage Environment

The π-type tubes used in high-pressure feedwater heaters operate at temperatures above 350°C. Depending on the size of the unit, they function under pressures of 30MPa or higher. The tubes also withstand high-speed water flow (over 3m/s) and vibrations, making the operating conditions harsh. Therefore, they require very high reliability, with a service life expectancy of over 15 years.

Specification Range of Products

  • Outer Diameter: Φ12mm ~ Φ25mm
  • Wall Thickness: 1.0mm ~ 4.0mm

Pi-type feedwater heater tube data

A pi-tube is bought as a finished shape, not as tube plus a bending instruction. The heater OEM drawing fixes the leg lengths, the bend radii and the orientation of the two legs, and the tube is formed, heat treated if required and tested in that shape before packing.

Tube form Pi (π) shaped bend, formed from a single straight length
Typical standards ASME SA-556 (welded carbon steel feedwater heater tube), SA-209 / SA-213 (seamless alloy), SA-688 (welded austenitic)
Grades SA-556 Gr. A2 / C2, SA-209 T1a, SA-213 T11 / T22, SA-688 TP304 / TP316L
Outside diameter 15.88 mm – 25.4 mm
Wall thickness 1.0 mm – 4.0 mm
Bend Bend radius and leg lengths to the customer drawing; bend flattening and wall thinning recorded
Testing Hydrostatic or eddy current on the straight length, then a second eddy current pass over the bends
Certificate EN 10204 3.1; 3.2 on request

Wall thinning on the outside of the bend is the acceptance point. Ask for the thinning percentage to be measured and reported per bend rather than on a sample, because a pi-tube that fails on site cannot be re-bent.

Related products

Further reading