Project Description
High Pressure Feedwater Heater Straight Tubes
Product Description
To reduce the loss of heat carried away by cooling water in condensers, feedwater heating is employed to minimize this loss. This involves installing high-pressure heaters after the high-pressure feedwater pumps to increase the temperature of the boiler feedwater, thereby enhancing economic efficiency and conserving coal resources. The heat exchanger tubes are a critical component of these heaters, available in various forms such as U-tubes, π-tubes (flat-bottomed tubes), and straight tubes.
Straight tubes are commonly used in fixed-tube sheet heat exchangers where the tube sheets at both ends are connected to the shell, creating a simple structure. However, they are suitable only when there is not a significant temperature difference between the hot and cold fluids, and mechanical cleaning of the shell side is not required. For slightly larger temperature differences and moderate shell-side pressures, an elastic compensation ring can be installed on the shell to reduce thermal stress.
Main Grades or Steel Levels
- ASME SA-556C2
- 20MnGJ
Standards for Products
- ASME SA-556M: Seamless cold-drawn carbon steel tubes for feedwater heaters
- GB/T 24591-2009: Seamless steel tubes for high-pressure feedwater heaters
Features of the Product
The tubes are long (up to over 35 meters in length) and thin (with a length-to-diameter ratio greater than 1000). Due to the requirements of production and usage environments for high-pressure heaters, they must meet high standards for straightness (full length passing through a ring gauge +0.02mm larger than the maximum outer diameter) and surface roughness. They must also be free from rust.
Usage Environment
The straight tubes used in high-pressure feedwater heaters operate at temperatures above 350°C. Depending on the size of the unit, they function under pressures of 30MPa or higher. The tubes also withstand high-speed water flow (over 3m/s) and vibrations, making the operating conditions harsh. Therefore, they require very high reliability, with a service life expectancy of over 15 years.
Specification Range of Products
- Outer Diameter: Φ12mm ~ Φ25mm
- Wall Thickness: 1.0mm ~ 4.0mm
